Operator Terminal System Manual - 11276916.pdf

11.2 Downloading the system program
System Manual – DOP11A Operator Terminals
Appendix
Downloading the system program
The operator terminal is delivered with a system program (operating system) stored in
the terminal memory. You can replace the system program, e. g. to update it to a newer
version. The following equipment is required to load the system program into the
terminal:
PC
Connection cable between PC and operator terminal (PCS11A)
PC program SYSLOAD.EXE (System loader, icon in the DOP Tools program group)
File with new system program
Proceed as follows to download the system program:
1. Connect PC and operator terminal using the connection cable.
2. Start the PC program by selecting [Programs] / [Drive Operator Panels DOP] / [DOP
Tools] / [DOP System Loader] from the startup menu.
No settings are required in the operator terminal.
You can define the communication port and the transfer speed under [Options] / [Comm
Settings] in [DOP-Tools] / [DOP System Loader].
The checkbox for overwriting the controller driver must be activated when replacing the
system program with an elder version.
If downloading a new system program (*.bin file) fails after you have clicked on [Send]
in [DOP-Tools] / [DOP System Loader], the terminal will automatically enter sysload
mode. You can retry to download the system program once the terminal has entered
sysload mode.
11
277