Operator Terminal System Manual - 11276916.pdf

System Manual – DOP11A Operator Terminals
Programming
Graphic display and control
Bar graph Object that displays integers or floating point numbers in the form of bar graphs.
[General] tab
10637EN
Parameters Description
Analog signal Signal address
Scale division Specifies which scale division is used.
Box Select whether you want to have a box drawn around the graph.
Scale ticks Specifies the interval between the indicated scale ticks.
Scale Select whether you want to have a scale displayed on the graph.
Minimum value Minimum value of the signal.
Maximum value Maximum value of the signal.
Pattern Specify whether you want the graph to be filled completely or dot-wise. For
DOP11A-20 only.
Direction Specify whether you want the border to appear on the top, bottom, right, or left.
Border style Specify whether you want the object to have a border.
Indicators Here you specify whether the highest or lowest value will be indicated for the signal
on the axis. The indicators are reset when starting the terminal. This reset can be
performed in run mode by selecting the graph with a mouse click and pressing the
Enter key. (Point to the graph if your terminal has a touchscreen.) The indicators
support 16-bit characters only.
Engineering units Is used for scaling the register value.
scaling
See section "General parameters" on page 114.
Scale Define a color for the scale in the object.
Fill Choose a filling color.
BG Define a background color for the object.
I
0
7
133