Operator Terminal System Manual - 11276916.pdf

Move
System Manual – DOP11A Operator Terminals
Programming
Graphic display and control
10596AEN
Under the [Move] tab, enter two analog signals the values of which determine the x
(width) and y (height) coordinates of the object.
If you enter an illegal value, for example a value that does not enable the object to be
displayed on the screen, the value will be ignored.
Signal Enter an analog signal.
Value from Enter the minimum value of the analog signal.
Value to Enter the maximum value of the analog signal.
From X / Y position
To X / Y-Position
Enter the x and y coordinates of the object, i.e. the pixel value on the screen at
which the value of the parameter corresponds with the value of the defined value.
Enter the x and y coordinates of the object, i.e. the pixel value on the screen at
which the value of the parameter corresponds with the value of the defined value.
I
0
7
123