City of Frisco Engineering Standards

Engineering Standards
The City requires the submittal of CAD files for all plats within the City of Frisco for
incorporation into the City’s GIS system. The Engineer must provide Grid Coordinates (State
Plane) or Surface Coordinates with Scale Factor. The electronic files shall include the following:
1. Two Monuments (with three-dimensional coordinates);
2. Markers at a minimum of two property corners (with three-dimensional coordinates);
3. Parcel boundaries; and
4. Right-of-way and easement dedications.
10.03 Final Plat Acceptance
A. Prior to Final Plat Acceptance, all required Monuments must be found and re-set if damaged
during construction.
1. The Surveyor will provide two Monuments acceptable to the Cityand establish grid
coordinates for the monuments in reference to the City of Frisco GPS Monuments.
2. Elevations will be established on the two monuments on the vertical datum in reference to the
City of Frisco GPS Monuments.
3. The three dimensional coordinates in grid coordinates established for these monuments will
be clearly shown on the face of the plat. A note shall be added to the plat specifying the grid
coordinates are not for design purposes.
4. The plat shall hold grid bearings and shall not be from an assumed north.
5. All distances shown on the plat will be surface distances.
6. Refer to Development Application Handbook for required language on plats.
7. In order to ensure that all necessary easements are reflected on the Final Plat, a preliminary
inspection should be completed after all construction work has been done before the Final
Plat is submitted for approval.
Section 10 – Survey Requirements May 2012 Page 10-3