City of Frisco Engineering Standards

SECTION 265620
LUMINAIRE FIXTURE
PART 1 - GENERAL
1.01 DESCRIPTION
A. All material, labor, equipment, tools and superintendence necessary to furnish and install
Luminaire Fixtures for City of Frisco standard street lighting.
1.02 REFERENCES
A. Manufacturer’s Standard Details and Specifications for Luminaire Fixture.
1.03 RELATED SECTIONS
A. Section 265619 – Luminaire Pole
B. Section 033101 – Drilled Shaft Foundation
C. Section 347113 – Barricades, Signs, and Traffic Handling
D. Section 260500 – Electric Conductor
E. Section 344135 – Ground Box
F. Section 260501 – Electrical Service
1.04 SUBMITTALS
A. Manufacturer’s Standard Details and Specifications.
B. The Contractor shall furnish four (4) sets of submittals of the aluminum decorative fixture to
the City. These submittals shall be approved by the City before the Contractor begins work.
C. Prior to beginning fabrication, two (2) copies of the completed material identification form
shall be furnished to the City.
PART 2 - PRODUCTS
2.01 MATERIALS
A. All materials furnished by the Contractor shall be new, UL-listed, meet NEMA, NEC,
AASHTO, and the Electrical Detail standard sheet requirements.
B. Contractor shall provide luminaire fixtures. The luminaire fixture shall be a Hadco Profiler
PA31 Series or Kim Archetype AR Series or approved equal and operate at 480 volts.
Luminaire optics will produce an IESNA cutoff light distribution type as noted on the plans.
Luminaire shall be 8 inches high by 33.75 inches in width with a housing made of low-copper
die-cast aluminum alloy. Luminaire shall be able to mount on 2 3/8 inch OD bracket arm.
Finish shall be electrostatically applied thermoset polyester powdercoat color Traffic Black
(RAL9017).
City of Frisco May 2012
Standard Technical Specification Luminaire Fixture 265620-1