TVG-Series System Guide v1-4 - SerVision

SerVision
TVG System Guide
Figure 125: Sensor Summary screen
Each sensor and activator in the system is configured in its own configuration screen. The configuration screens are
accessed from the Sensor Summary screen. Sensors connected to the unit through an ADAM module appear as
“External Sensors.” They are configured in the same way as sensors connected directly to the unit.
NOTE:
External sensors can only be enabled and configured if ADAM Sensors is enabled in the General
System Settings screen (see Configuring General System Settings, page 21).
To open the Sensor Summary screen:
• In the Main Menu, click Sensors.
To configure a sensor or activator:
1. In the Main Menu, under Sensors, click the sensor or activator (e.g., Sensor #1 to configure the sensor
plugged into In1). The relevant Sensor or Activator configuration screen opens:
Configuring Sensor and Activator Settings 111