TVG-Series System Guide v1-4 - SerVision

SerVision
TVG System Guide
Figure 192: Jumper connected to pins 2 and 3
4. Reconnect the power to the unit. When the startup process is completed (the Power LED on the front of the
unit flashes at frequent intervals), the default factory settings are restored.
5. Disconnect the power from the unit again.
6. Remove the jumper from the RS232/485 connector.
7. If you disconnected a PTZ controller before performing this procedure, reconnect the controller.
8. Reconnect the power to the unit.
Restoring Factory Settings 164