TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SerVision</strong><br />
<strong>TVG</strong> <strong>System</strong> <strong>Guide</strong><br />
Note: If a device is not enabled in the Default outline, it cannot be enabled in any other outline. In this case,<br />
the configuration screen of the device in the outline section will say the device is disabled (see figure 139). For<br />
information about activating a device in the Default outline, see page 111.<br />
Figure 139: Dev ice that is not enabled in the Default outline<br />
7. Select the desired settings for the device in the current outline.<br />
Note: For information about the settings, please refer to the section of this manual that relates to each type of<br />
setting, as follows:<br />
•• Video Motion Detection (VMD), page 88<br />
Note: If VMD is enabled for a camera in the default outline, it cannot be disabled in any other outline.<br />
Similarly, VMD regions can only be defined and modified in the default outline; they are applied in all<br />
outlines in accordance with their definitions in the default outline.<br />
•• Configuring Video Lost, page 94<br />
•• Video Recording Settings, page 96<br />
•• Configuring Sensor and Activator Settings, page 110<br />
Note: In the Camera screens, when recording is by event, the sensors and activators can only be selected<br />
as triggers if they are already enabled in the current outline. Thus, for example, if you want to select<br />
Sensor 1 as a trigger for the Camera 1 recorder, you must first enable Sensor 1 in its configuration screen,<br />
and then select it in the Camera 1 configuration screen.<br />
8. Click Update.<br />
9. Repeat steps 6–8 for each of the cameras, sensors, and activators connected to the <strong>TVG</strong>.<br />
10. Save the changes. The settings will be implemented after the unit is restarted (see Saving Configuration<br />
Changes, page 125).<br />
Activating Outlines Manually<br />
If more than one outline is defined, and outline switching is not performed automatically by the system (by means<br />
of Sensor 1 or through a schedule), you can manually select the outline you want to run at any time. In addition, you<br />
can specify that the selected outline be loaded automatically when the unit first starts up. In this case, the selected<br />
outline replaces the Default outline as the system default.<br />
Defining Alternate Outlines 123