TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SerVision</strong><br />
<strong>TVG</strong> <strong>System</strong> <strong>Guide</strong><br />
Field<br />
Go To Preset<br />
Description<br />
All PTZ cameras connected to the <strong>TVG</strong> that support presets are listed below this heading.<br />
If you want one of these cameras to automatically aim at a preset location when a motion<br />
detection event begins, beside the name of the camera, select the number of the preset<br />
location.<br />
Note: Preset locations are defined and assigned numbers using a client application such<br />
as the MultiClient. For additional information, please refer to the relevant client application<br />
guide.<br />
Note: If no PTZ cameras are connected to the unit, this field does not appear.<br />
11. Under On Motion Ended, select the actions that the <strong>TVG</strong> should perform when a motion detection event<br />
ends, as described above.<br />
Configuring Video Lost<br />
The <strong>TVG</strong> monitors the camera connections. If the video signal from a camera is lost – i.e., the <strong>TVG</strong> is not receiving<br />
video from it, either because of a malfunction in the camera, or because the camera has been disconnected from the<br />
unit or from its power source – the unit can respond in any or all of the following ways:<br />
• Upload video of the event to an FTP server on the internet (see Automatically Uploading Video to an AVV<br />
Server, page 64). If e-mail notification recipients are defined in the SMS and E-mail screen, an e-mail<br />
message is sent to all the recipients when the Video Lost event begins and a second e-mail is sent when the<br />
video is successfully uploaded and is available for downloading by users. Each e-mail notification includes a<br />
link to the video file on the server and a picture of the event.<br />
• Send event notifications to the SMS and/or e-mail recipients defined for the system (see SMS and E-mail<br />
Notifications, page 58). If AVV is activated, e-mail notifications include a link to video of the event that<br />
includes the seconds preceding the time when the video signal was lost (the pre-record; see Video Recording<br />
Settings, page 96). Video-Restored e-mail notifications can optionally include a picture of the event.<br />
• Turn an activator on or off.<br />
• Move any PTZ camera connected to the <strong>TVG</strong> that supports presets to a preset location.<br />
These actions can be implemented when the event begins, when it ends, or both.<br />
To configure video lost detection:<br />
1. In the Camera configuration screen, under Video Lost, select the actions that the <strong>TVG</strong> should perform if<br />
video reception from the camera is interrupted, as described below.<br />
Figure 104: V ideo Lost settings<br />
Configuring Camera Settings 94