TVG-Series System Guide v1-4 - SerVision

SerVision
TVG System Guide
To modify the loop interval and screen saver settings:
1. In the Config menu, select TV-Out Params. The TV-Out Params screen opens:
Figure 218: TV-Out Params screen
2. Under Switch Delay, select the up arrow to the left of the field or the down arrow to the right of the
field to modify the loop interval. This value only affects the full-screen rotating display. This value indicates
how many seconds the display will remain on each camera before switching to the next camera when the
rotating display is active.
3. If you want to activate the screen saver, under Screen Saver, select Enabled. The Timeout field is added
to the screen, and displays the current timeout value in hours and minutes (HH:MM format):
Figure 219: Screen Sav er enabled
Appendix A: Viewing Video on a CCTV Monitor (TV-Out) 192