TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SerVision</strong><br />
<strong>TVG</strong> <strong>System</strong> <strong>Guide</strong><br />
•• By Event: Recording only takes place when an event occurs<br />
•• None: Recording is not activated for the camera<br />
If you select By Event, the fields required to configure the event-triggered recording are added to the screen:<br />
Figure 105: Settings for ev ent-triggered recording<br />
2. Under Recording Quality, select the recording quality (High, Medium, or Low).<br />
Note: For information about the data rates represented by the standard quality levels and about selecting<br />
custom recording quality settings, see Advanced Recorder Settings, page 97.<br />
Note: The percentage of available recording space that is allocated to the camera is indicated in the screen.<br />
(In the illustration above, 24% is allocated to the camera.) This value is set in the Advanced Settings. For<br />
additional information, see Advanced Recorder Settings, page 97.<br />
3. If the recorder is event-triggered, select the triggers that will cause the recording to start:<br />
•• VMD: If VMD is enabled for the camera (see Video Motion Detection (VMD), page 88), and you want<br />
VMD events to trigger event recording, select VMD.<br />
•• Sensor events: If you want sensor events to trigger event recording, select the sensors you want to<br />
function as triggers. For example, select S1 to use Sensor 1 as a trigger.<br />
•• Activator events: If you want activator events to trigger event recording, select the activators you want<br />
to function as triggers. For example, select A1 to use Activator 1 as a trigger.<br />
Note: VMD is not automatically selected when it is enabled. Furthermore, if none of the sensors or activators<br />
is selected, and VMD is not selected, no recording will take place.<br />
4. If the recorder is event-triggered, fill in the pre-record and post-record values as follows:<br />
•• Pre-record: The number of seconds before each event that should be included in the recording of the<br />
event. Range: 0–9 seconds.<br />
•• Post-record: The number of seconds following each event that should be included in the recording of<br />
the event.<br />
CAUTION: When you update the quality or size values in this screen, all the recorded video from this camera<br />
that is currently stored on the storage media is deleted.<br />
Advanced Recorder Settings<br />
Advanced settings allow you to customize the recorder's video quality settings. You can choose whether or not<br />
recordings are automatically erased to make room for new recordings, and set the allocation of disk space among all<br />
the recorders connected to the <strong>TVG</strong> unit.<br />
Configuring Camera Settings 97