TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SerVision</strong><br />
<strong>TVG</strong> <strong>System</strong> <strong>Guide</strong><br />
•• Under Preset, click/tap the Up and Down arrows ( and ) until the number you want to assign to<br />
the preset is displayed.<br />
•• Select Set.<br />
The location is assigned to the preset number.<br />
Recording Status Display<br />
If the unit was configured to display the system's recording status in the monitor (see Display Recording Status,<br />
page 31), the status is displayed in the lower-right corner of the screen. The status information indicates whether<br />
video recording is functioning properly and, if it is, displays the current recording status of each camera.<br />
When recording is functioning properly, a status message based on the following template is displayed:<br />
HD:OK REC 0[WP:]X0 1[WP:]X1 2[WP:]X2 3[WP:]X3<br />
The template contains the following items:<br />
Item<br />
HD:OK<br />
REC<br />
0[WP:]X0<br />
1[WP:]X1<br />
2[WP:]X2<br />
3[WP:]X3<br />
Description<br />
Hard drive is functioning properly (status: OK)<br />
Recording is functioning properly<br />
Camera 1 recording status<br />
Camera 2 recording status<br />
Camera 3 recording status<br />
Camera 4 recording status<br />
The recording status displayed for each camera has two parts:<br />
• WP: appears if write protection is enabled for the camera. Otherwise, it does not appear.<br />
• Xi: is the current recording status of the camera. It can be one of the following values:<br />
Recording Status<br />
N<br />
C<br />
T<br />
W<br />
w<br />
Description<br />
No recording<br />
Continuous recording<br />
Event-triggered recording: recording is not currently underway<br />
Event-triggered recording: recording of the pre-alarm part is underway<br />
Event-triggered recording: recording of the Event, and/or of the post-alarm<br />
part, is underway<br />
For example, HD:OK REC 0C 1WP:C 2T 3N means that four cameras are connected to the unit, all four are<br />
recording as configured, and their recording statuses are as follows:<br />
• Camera 1: Continuous<br />
• Camera 2: Continuous and write-protected<br />
• Camera 3: Event-triggered (no recording is underway)<br />
• Camera 4: No recording<br />
Appendix A: Viewing Video on a CCTV Monitor (TV-Out) 198