TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>SerVision</strong><br />
<strong>TVG</strong> <strong>System</strong> <strong>Guide</strong><br />
Figure 217: Picture Params screen<br />
2. Under Camera, select the number of the camera whose settings you want to modify. Video from this camera<br />
is displayed in the upper-right corner of the screen.<br />
3. Under Brightness, select the arrows to the right or left of the slider bar to adjust the brightness, as follows:<br />
•• Single arrows –<br />
and : Adjust the brightness in small increments.<br />
•• Double arrows – and : Adjust the brightness in large increments.<br />
The camera settings are changed, and the video displayed in the camera pane in the upper left of the screen<br />
changes accordingly.<br />
4. Under Contrast, select the arrows to the right or left of the slider to adjust the contrast, as described in step 3<br />
above.<br />
The camera settings are changed, and the video displayed in the camera pane in the upper left of the screen<br />
changes accordingly.<br />
5. When the brightness and contrast are set as you want them to be, exit the menu by selecting one of the<br />
following buttons:<br />
•• Done: Return to live video display. The settings remain in effect until they are manually changed again<br />
or until the <strong>TVG</strong> restarts. When the unit restarts, the previous settings are implemented again.<br />
•• Save: Save the settings on the <strong>TVG</strong>. The next time the unit restarts, the unit’s configuration is updated<br />
with the new settings. The settings remain in effect until they are manually changed again, either on the<br />
monitor or in the configuration utility.<br />
•• Back: Return to the Config menu. The settings remain in effect until they are manually changed again or<br />
until the <strong>TVG</strong> restarts. When the unit restarts, the previous settings are implemented again.<br />
Adjusting Loop Interval and Screen Saver Settings<br />
Initial loop-interval and screen-saver settings are set in the configuration utility (see Configuring a CCTV Monitor<br />
(TV-Out), page 28). You can modify these settings on the monitor, and, if you wish, save the new settings to the<br />
unit’s configuration.<br />
Appendix A: Viewing Video on a CCTV Monitor (TV-Out) 191