TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SerVision</strong><br />
<strong>TVG</strong> <strong>System</strong> <strong>Guide</strong><br />
Saving Configuration Changes<br />
As you make changes in each screen, you click the Update button to save the changes. However, in order to<br />
complete the save operation and update the <strong>TVG</strong>, you need to carry out the steps described below. Most<br />
configuration changes only take effect after you carry out all of these steps.<br />
NOTE:<br />
Changes in the WiFi and Network Priorities, changes in the Modem screen of the MVG and UVG,<br />
and modifications to camera brightness, contrast, and saturation settings are implemented immediately<br />
when you click the Update button. To save them permanently, the changes must be saved, but<br />
restarting the unit is not necessary. All other configuration changes are implemented only after they are<br />
saved and the system is restarted.<br />
To save all changes:<br />
1. Do one of the following:<br />
•• In the orange Update Confirmation (ATTENTION) message below the Main Menu, click “Click here to<br />
go to Save Settings page.”<br />
•• In the Main Menu, under <strong>System</strong>, click Save Settings.<br />
The Save Settings screen opens:<br />
Figure 140: Sav e Settings screen<br />
2. In the Save Settings screen, click Save Changes to <strong>System</strong>. The unit stores the changes permanently,<br />
and the <strong>System</strong> Restart Page screen opens:<br />
Saving Configuration Changes 125