TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SerVision</strong><br />
<strong>TVG</strong> <strong>System</strong> <strong>Guide</strong><br />
Figure 27: TV -Out Disabled message<br />
3. Fill in the fields as follows:<br />
Field<br />
Display type<br />
Rotate delay<br />
Display Switch Via<br />
Sensor<br />
Cameras<br />
Description<br />
Select the desired layout for the video display on the monitor:<br />
• Split Screen: Divides the screen so that video from all the<br />
cameras is visible all the time<br />
• Full Screen – Camera #: Displays video from the specified<br />
camera in full-screen mode<br />
• Full Screen – Rotate: Loops through all of the cameras,<br />
displaying each in full-screen mode for the number of seconds<br />
specified under Rotate delay<br />
If you selected the Full Screen – Rotate display type, specify the number of<br />
seconds you want the video from each camera to be displayed before it is replaced<br />
with video from the next camera.<br />
Note: This field only appears if the Full Screen – Rotate display type is selected.<br />
Select this option if a switch is connected to the relevant sensor connector on the<br />
unit (In6 on the HVG; In4 on the MVG, and UVG; In1 on CVG and CVG-M models),<br />
and you want to use the switch to cycle through the various display types.<br />
Note: This option is only fully activated if it is selected here and configured in the<br />
appropriate sensor configuration screen (for HVG, MVG, or UVG, the Sensor 4<br />
configuration screen; for CVG or CVG-M, the Sensor configuration screen), as<br />
described under Configuring a Sensor to Control CCTV Display, page 116.<br />
Note: On CVG and CVG-M models, this option should not be selected if the sensor<br />
connector (In1) is used for an outline switch. For additional information, please refer<br />
to the unit’s installation guide.<br />
Select the cameras that will be accessible via the monitor. Cameras that are not<br />
selected do not appear in the monitor at all. Video from these cameras cannot be<br />
viewed on the monitor and the cameras cannot be configured through the monitor.<br />
Configuring <strong>System</strong> Settings 30