TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>SerVision</strong><br />
<strong>TVG</strong> <strong>System</strong> <strong>Guide</strong><br />
7. If you do not want audio to be incorporated with the video recorded from the camera, under Audio<br />
Recording, clear the Enabled checkbox.<br />
Note: The Audio Quality field is not currently in use. All audio recordings have medium quality.<br />
Note: If recording is not activated, this checkbox cannot be cleared.<br />
8. If you want to use the <strong>TVG</strong>’s VMD features to detect and respond to motion in the camera’s field of view,<br />
under Motion Detection (VMD), select Enabled. Then follow the instructions below (Video Motion<br />
Detection (VMD), page 88).<br />
Note: Be aware that on PTZ-controlled cameras each change of the camera position is interpreted by the<br />
VMD system as an event.<br />
9. Configure the unit's response to interruptions in the transmission of the video signal from the camera to the<br />
unit as described below (Configuring Video Lost, page 94).<br />
10. Configure the camera’s recorder as described below (Video Recording Settings, page 96).<br />
11. Click Update. Changes to brightness, contrast, and saturation are implemented immediately. Save the settings<br />
to implement them permanently. Save the settings and restart the unit to implement all other changes (see<br />
Saving Configuration Changes, page 125).<br />
Configuring PTZ<br />
This section explains how to configure the pan-tilt-zoom (PTZ) controls of cameras that support these features.<br />
Once the controls are configured, the camera can be aimed and zoomed remotely using any of the client<br />
applications.<br />
NOTE:<br />
For information about connecting the PTZ controller to the <strong>TVG</strong> unit, please refer to the unit’s<br />
installation guide.<br />
To configure pan-tilt-zoom controls (PTZ) in cameras that support these features:<br />
1. In the Camera configuration screen, under Camera Control (PTZ), select Enabled. The fields required to<br />
configure the PTZ settings are added to the screen:<br />
Figure 98: PTZ settings<br />
2. Fill in the fields as follows:<br />
• Field<br />
Protocol<br />
• Description<br />
Select the communication protocol used by the camera for PTZ control.<br />
Note: Consult the camera documentation or the camera vendor for this information.<br />
Configuring Camera Settings 87