TVG-Series System Guide v1-4 - SerVision

SerVision
TVG System Guide
Figure 194: Full-screen display
When the TVG unit starts up, the monitor displays a startup screen containing the name of the unit, its private IP in
the local network, the firmware version, and a video pane displaying live video from one of the cameras connected
to the unit. If mouse/touch is activated, a Done button also appears. After a few seconds, this display is replaced by
the default video display.
Figure 195: Startup screen
NOTE: If the unit is configured to connect to an external LAN using DHCP (see LAN Settings, page 38),
[DHCP] appears after the IP address. If the IP address was not yet assigned when the startup screen was
displayed, 0.0.0.0 appears instead of the IP address. If mouse/touch controls are available (see below),
you can see the correct IP in the Sys Info screen (see Viewing System Information on the Monitor,
page 196) after it is assigned.
The default display can be changed on the fly using one or both of the following methods:
Appendix A: Viewing Video on a CCTV Monitor (TV-Out) 171