TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
TVG-Series System Guide v1-4 - SerVision
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>SerVision</strong><br />
<strong>TVG</strong> <strong>System</strong> <strong>Guide</strong><br />
Field<br />
GGA to server<br />
GGA to serial<br />
NMEA server<br />
NMEA port<br />
NMEA frequency<br />
RMC history<br />
(MVG only)<br />
Description<br />
Select this option if you want to send GPS data in GGA syntax to an NMEA server.<br />
Select this option if you want to send GPS data in GGA syntax to a device connected to<br />
the serial port of the <strong>TVG</strong> unit. The data is sent at 4800 baud, 8 bits, no parity, one<br />
stop bit (8N1).<br />
If you opted to send either RMC or GGA data to an NMEA server, fill in the IP address<br />
or hostname of the server.<br />
If you opted to send either RMC or GGA data to an NMEA server, fill in the port used to<br />
by the server to receive NMEA data.<br />
If you opted to send either RMC or GGA data to an NMEA server, specify how often the<br />
NMEA data should be transmitted to the server, in seconds. Recommended value: 30.<br />
Note: This value should be a multiple of the GPS Frequency value, and should not be<br />
higher than the GPS Frequency (i.e., the NMEA Frequency should not be set to a<br />
smaller number of seconds than the GPS Frequency). If it is, the GPS Frequency<br />
actually follows the NMEA Frequency.<br />
If you chose to send RMC data, specify how much data should be stored for sending<br />
later if the unit fails to send the data to the RMC server.<br />
Erasing Recorded GPS Data<br />
Recorded GPS data is normally stored on the unit's storage media until it is over-written by newer data. You can<br />
also erase all GPS data from the unit manually.<br />
To erase all recorded GPS data from the unit's storage media:<br />
• In the <strong>System</strong> Summary screen, under GPS, click Erase GPS Recordings. The recordings are erased.<br />
Figure 24: Erase GPS Recordings<br />
Note: The Erase GPS Recordings button only appears if GPS recording is enabled in the General<br />
<strong>System</strong> Settings screen (see Configuring GPS, page 26).<br />
Configuring a CCTV Monitor (TV-Out)<br />
If a video monitor is connected to your <strong>TVG</strong>, you must activate and configure it before you can see video from the<br />
<strong>TVG</strong> on it.<br />
NOTE:<br />
For information about setting up a CCTV monitor, please refer to your unit’s installation guide. For<br />
information about viewing video on a connected CCTV monitor, see Appendix A: Viewing Video on a<br />
CCTV Monitor (TV-Out), page 170.<br />
Configuring <strong>System</strong> Settings 28