(VERSION-IV) - DVC :: Consumer Login

2.5
c) The Contractor shall get all his Lifting equipments and tackles thoroughly
examined / tested through a Competent Persons, approved by the local state
government, where the work is being undertaken.
d) Before Start of work by the Contractor, the Contractor shall present his Personal
Protective equipments to Head of DVC Safety Deptt, and Engineer In charge, for
inspection, who will inspect these equipments for necessary legal compliance. Only
after this inspection and clearance in writing, above referred items shall be used or
issued by the Contractor.
e) Before using the lifting equipments and other safety related items, the contractor
shall present these to Head of DVC Safety Deptt, and Engineer In charge, for
inspection, who will inspect these equipments for its safety. Only after their
clearance in writing, these items shall be used by the Contractor. However, all
liabilities for statutory violations for these equipment shall be of the Contractor.
Before Start of the contract, the Contractor shall provide appropriate Safety
Training to all his workers of at least one full day duration, through an external
agency, with faculty having the qualification as mentioned in the Factories Act/
State Rules for the Safety Officer, and having minimum 5 years of power plant site
exposure, with regard to implementing safety provisions.. Only those who are
trained, as above, shall be allowed for issue of Gate Pass.
f) Before Start of work by the Contractor, the Contractor shall get occupational
health examination of his workers, working/ to work in hazardous activities
through a Medical Practitioner, approved by the State Government, and
subsequently as mentioned in the state factories rules.
g) In case any accident occurs and DVC Officials investigate it, the Contractor
shall provide full cooperation in conduct of inquiry, conducted by the DVC
officials, in case of any accident at his workplace or to his worker.
e) Wherever there is probability of fall of worker/ material from more than 8 Ft, to
prevent his fall, the contractor shall provide Safety Harness to all his workers and
ensure its use. He shall also provide safety net below such work place. He shall
ensure compliance of all provisions of Permit for working at height devised by
DVC. If the fall arrester is provided by DVC, the Contractor shall ensure its right
use.
The contractor shall use only double insulated power tools shall be used at the
construction place. He shall only use 3 Core cable for Single phase Supply and 4
Core Cable for 3 Phase supply. For all electrical connections appropriate ELCB
shall be used by the Contractor.
a) In no case any electric supply shall be taken through loose wire like supply
without Plug Top.
W& P Manual – 2012 Page 173