d-lab.2, d-lab.2plus, netlab.2plus - D-Lab 1

Settings and Configurationsd-lab.2, d-lab.2plus, netlab.2plus: Operation* Paper width 3.25 inch (82 mm) and 4.50 inch (114 mm)As there are only 15 different switch/slide combinations for 16 different paper width, only15 of the 16 available paper width can be set at the same time. Therefore the same codehas been used in the AgfaPhoto standard for the two above mentioned widths. If you keepthe AgfaPhoto standard only one of these two width can actually be used.If you want to use both widths, the code of another paper width must be used for one ofthese two widths, e.g. the code for paper width 89 mm. But in this case the paper width89 mm can no longer be used.4.3.7 Defining Cut LengthsCall up: Press in this order:SettingsMachine settingsCut lengthThe screen Setting of cut lengths opens. Press New cut length andenter the cut length (range 89–457 mm). Press Save.070The defined cut lengths are displayed in pulldown menus when order configurations arecreated or edited (see Defining and Editing Order Configurations in this chapter).NoteFor an overview of common print formats refer to the tables on the next page. Usuallythe print sizes are rounded values. To get the actual size set the value of the cut length(paper length) in the respective table.4-18 2005-05-01 / PN 04092_01 AgfaPhoto