d-lab.2, d-lab.2plus, netlab.2plus - D-Lab 1

Productiond-lab.2, d-lab.2plus, netlab.2plus: Operation6.2.1.5 Coding the Paper MagazineThe code for the inserted paper must be set on the paper magazine. After the magazine isinserted the machine detects the paper width and surface by the set code. By means of the slides on the magazine thewidth and surface of the inserted paper mustbe coded as defined in the paper settings(see Defining Paper Widths and DefiningSurfaces in Chapter 4).CAUTION!A machine can only detect the papercorrectly if the magazine is codedprecisely as defined in the paper settings.Codes that are not matching causeproduction problems.6.2.1.6 Inserting a Paper MagazineNoteDo not use two paper magazines with the same code at the same time in the machine!MSC1B035bNoteAfter a paper magazine was inserted theMinilab determines the paper length. For this,the paper moves to the cutter and back. Toavoid fogging of the paper both Printer doorsmust be closed for this procedure. Open the door to the paper magazine. Place the paper magazine on the guide railsand push it in until it locks audibly. Close the door to the paper magazine.The screen shows a popup asking if theleading paper edge should be cut.6-30 2005-05-01 / PN 04092_01 AgfaPhoto