d-lab.2, d-lab.2plus, netlab.2plus - D-Lab 1

Settings and Configurationsd-lab.2, d-lab.2plus, netlab.2plus: OperationSelf-learning TFS curves:– Learning phase: At least 20 different films of the same film type with at least sixnegatives each must be scanned. The films should be exposed on different cameras ifpossible.The learning TFS is based on the DX code. As the fluctuations due to film processingdifferences are stronger than the differences among film types, the best results areobtained with films that have been processed, if possible, in an identical or at leastsimilar way.During the learning phase the factory-set standard values are used.– Only after the learning phase, i.e. from film 21 of the same type on, the film typespecific values determined during the prescan have an effect: The TFS curves are usedfor logic calculations.The dominant parameters are effective right from the first film of a type, i.e.independent of the learning process of TFS curves.NoteUse different films of the same type for the learning, do not use the same film 20 timesas otherwise the statistics will be falsified!Use of the learning TFS Press Learning TFS used to activate/deactivate this function.Reset of learning TFS Press Learning TFS Reset:The determined values for all films are reset,i.e. all curves are deleted.We recommend to activate this reset only ifthe production quality deteriorates. Then thelearning process begins again.4-64 2005-05-01 / PN 04092_01 AgfaPhoto