d-lab.2, d-lab.2plus, netlab.2plus - D-Lab 1

Testsd-lab.2, d-lab.2plus, netlab.2plus: Operation5.2.2 Initial PBL and MBL after the Machine InstallationProceed with the following steps: Use the factory-defined paper configurationsor create the required configurations (see Defining and Editing Paper Configurations inChapter 4). Define the master paper (see PrinterSettings in Chapter 4):Usually the machine comes with a factorysetmaster paper for the first startup.After a new software installation withoutdata transmission from a previous version,automatically that paper will be entered asmaster paper, which is used for printing thefirst PBL.Check if the settings are correct (seePrinter Settings in Chapter 4); ifnecessary define another paper asmaster paper (the most frequently usedpaper in the lab).If the master paper is changed an MBLwill be printed automatically. Print a PBL (see Printing a PBL Test in thischapter):make sure to use the master paper;activate with laser point. Print an MBL (if this was not doneautomatically as described above in theprevious paragraph) (see Printing an MBLTest in this chapter). Print a PBL with laser point for all otherpapers to be used. This must be done rightafter an MBL was printed, to ensure that themachine is in the same condition for bothtests.Now the Printer is calibrated for all papers: The production can be started.We recommend to save the database after a PBL was printed for all papers. By this it ispossible to load the values back into the machine, if necessary,(see Save and Load Settings and Configurations in Chapter 4).5-4 2005-05-01 / PN 04092_01 AgfaPhoto