d-lab.2, d-lab.2plus, netlab.2plus - D-Lab 1

General Description, Work Routines and Operationd-lab.2, d-lab.2plus, netlab.2plus: Operation2.5.4 Switching the Machine On and Off with the Main BreakerCAUTION!Only use the main breaker in emergencies to switch off the machine.In normal operation always use the routine End of work > Shutdown to switchoff the machine (see End of Work and Shutdown in this chapter); do not switchoff the main breaker (1)!If for technical reasons it is necessary to switch off the machine completely, e.g. forlonger down times (see Chapter 11), for some maintenance routines (see Chapter 8)or for changing the chemicals (see Changing chemicals in Chapter 3), shut down themachine first as described in End of Work and Shutdown in this chapter, and then switchoff the main breaker.If the machine is switched off with the main breaker without shutdown, this may– (applies only to d-lab.2 with gas laser, Type 8060/260 and d-lab.2plus with gas laser, Type8060/261)reduce the service life of the blue/green laser considerably (failure of after-cooling).– cause problems with the main computer; the operating system may have to bereinstalled,– cause paper jams if not all prints have left the Paper Processor.If the machine was switched off via the main breaker wait at least one minute before youswitch on again. Otherwise the hard disc of the main computer may get damaged.2-20 2005-05-01 / PN 04092_01 AgfaPhoto