d-lab.2, d-lab.2plus, netlab.2plus - D-Lab 1

Settings and Configurationsd-lab.2, d-lab.2plus, netlab.2plus: Operation4.4.7 Paper Processor SettingsThe following settings and calibrations must be made for the Paper Processor:– Setup of replenishment rates– Setup of temperatures for chemical solutions / calibration of temperature sensors– Calibration of water pumps4.4.7.1 Setting the Replenishment RatesThe replenishment depends on the throughput, i.e. it depends on the actually processedpaper per day. To keep the production consistent, more chemicals and water must bereplenished with a low throughput rate than with a high throughput rate. Thereby wedifferentiate between normal, increased, and maximum replenishment. This means thatthe normal replenishment rates are increased by the entered factor for the increased orthe maximum replenishment rate. The software calculates every day the averagethroughput of the last 5 days and sets the appropriate replenishment automatically. Incase of less than 10 m 2 throughput the increased replenishment and for less than 5 m 2the maximum replenishment are automatically activated (these throughput thresholds arepreset default values; they can be changed if necessary; see section Paper Processor inChapter 9).If the machine is put in operation for the first time or if it was switched off for severaldays, an initial value must be entered (see next page).CAUTION!The preset reference values are adjusted to AgfaPhoto chemicals (Easy Box 110)and AgfaPhoto paper. Therefore we recommend to change the set values only ifthese value fail to produce optimum print results.If necessary the value can be reset to default.NoteThe replenishment rates for the individual solutions DEV (developer), BX (bleach-fix),and STB (stabilizer) cannot be changed separately. If the replenishment rate is changedfor one solution, the other two solutions are automatically changed by the same ratio.4-34 2005-05-01 / PN 04092_01 AgfaPhoto