d-lab.2, d-lab.2plus, netlab.2plus - D-Lab 1

Testsd-lab.2, d-lab.2plus, netlab.2plus: Operation21 23 In a darkroom insert the chemical controlstrip in the controls strip box in such a waythat the notch is on the bottom right handside (smooth side – emulsion side – facingdownwards; see Figure).If the test strip is accidentally insertedupside down. the developed test usuallyshows distinctive dirt marks (emulsion sideup) or the pre-exposed measuring fields arefogged and cannot be evaluated any more.dlab2608(1) Control strip box(2) Emulsion side / photographic layer(3) Notchdlab2195 Press in this order:TestControl stripChemical control stripThen a prompt pops up to insert thechemical control strip. Place the control strip box on the providedholder. Close the Printer front door and pressContinue:The control strip is transported into thePaper Processor and processed there.A message indicates when the box should beremoved. Remove the box or leave it in themachine until the next test. Analyze the developed chemical controlstrip. A first evaluation is possible by comparingthe developed control strip with thereference strip enclosed in the box (placeboth strips side by side and compare them indaylight conditions). Use a densitometer fora more detailed evaluation (instructions areincluded in every package).If the densities in the measuring fields of the chemical control strip correspond to thenominal values the production can be started. If not, the chemicals must be replaced (see Chapter 3).Professional evaluation of the tests by AgfaPhoto is also possible. Please contact thesales organization.■5-24 2005-05-01 / PN 04092_01 AgfaPhoto