d-lab.2, d-lab.2plus, netlab.2plus - D-Lab 1

d-lab.2, d-lab.2plus, netlab.2plus: OperationTroubleshootingCheck if paper jam is still reported.Pull out the sheet transfer (ST).Check the print drum in the print engine(PE):Take out the top guide plate, turn theprint roller forward by hand to transportout any paper that may still be inside.Special case:A paper jam occurs during shutdown of the machine or during reset.The paper jam is only reported when the machine is started again: during this time, theInfo function cannot be called up.7.7.2 Paper Jam in the PrinterApplies to d-lab.2Proceed as follows in case of a paper jam in the Printer part:– The sequence control tries to transport all paper out of the Printer and through thepaper processor. In case of an actual mechanical problem this is not possible.– All papers, which are past the location of the paper jam in paper transport direction,are still transported and developed.– All prints in the area of the paper jam must be removed. Watch out for small paperremainders.– Assemblies which have to be pulled out of the Printer to remove jammed paper arenot energized.– The Printer will automatically be ready for printing once the operator has removed thejammed papers and cleared the error message or triggered a reset.7AgfaPhoto 2005-05-01 / PN 04092_01 7-15