d-lab.2, d-lab.2plus, netlab.2plus - D-Lab 1

d-lab.2, d-lab.2plus, netlab.2plus: OperationSettings and Configurations4.8.4 Defining and Editing Order Configurations of the Reproduction TypeOrder configurations of the Reproduction type are used to print image files withoutautomatic image improvement and without adaptation of the image size to the paper.Applies only to d-lab.2/2plusOrder configurations of the reproduction type can only be defined for file prints.The following table offers an overview about the functions which are active or inactive inthe Reproduction mode:4Repro mode TFS off TFS onPaper LUT yes yes yesColor management no yes yesSharpening no yes yesLogic calculation for the individual image no no yesLogic calculation over all images of an order no no yesFor foreseeable results the pixel size of the image file must be known as it is printed 1:1(image size) with 400 dpi. Printing is without preview; the configuration cannot bechanged. The image is printed in the center of the paper.If the image file is– too big with respect to the paper size, the image is cut.– to small with respect to the paper size, the image gets white borders.– approx. 3 times smaller than the paper size, image processing artifacts may occur.NoteIn an existing order configuration the setting for Config. type can no longer bechanged. If you edit an order configuration the Config. type button is inactive.AgfaPhoto 2005-05-01 / PN 04092_01 4-123