d-lab.2, d-lab.2plus, netlab.2plus - D-Lab 1

Productiond-lab.2, d-lab.2plus, netlab.2plus: Operation– Adjust: Shorter side orAdjust: Longer sideThe complete digital image is printed; the cut length is variable.. One side of thedigital image is adjusted to the paper width: either shorter side or longer side.Noteabout Adjust: Longer sideNot recommended for paper widths < 127 mm / 5 inches (results in very small prints).If this option is used for 5 inch (127 mm) and 6 inch (152 mm) paper widths, a per formacut length > 152 mm must be entered in the order configuration to receive a correct cutlength corresponding to the aspect ratio of the image file.– The back print includes the file name of seven characters maximum.– The file name is printed on the index print with nine characters maximum.– The sorter moves automatically to the next bucket after 55 prints (up to size 13x18) orafter 43 prints (in case of bigger sizes). When removing the prints consider that theyare distributed in several buckets in case of big orders!– Productivity for file prints:Upon printing of image files > 50 MB on large formats only a low productivity will beobtained.Example:File size 100 MBPrint format 30x45Duration up to 10 minutesNoteTo following points should be observed for images created with an image processingprogram:– Files must be saved in the formats “.tif”, “.bmp”, or “.jpg”.– Use a Gamma value of 1.8.– Images must be available in RGB mode. Images in other color modes, e.g. CMYK, mustbe converted externally to RGB (conversion on the Minilab is not possible).6-56 2005-05-01 / PN 04092_01 AgfaPhoto