d-lab.2, d-lab.2plus, netlab.2plus - D-Lab 1

Settings and Configurationsd-lab.2, d-lab.2plus, netlab.2plus: Operation4.8.1 Defining and Editing Order Configurations of the Single TypeNoteApplies to d-lab.2/2plusIn an existing order configuration the settings for Config. type and for Film mask canno longer be changed. If you edit an order configuration the Config. type button isinactive. If you change the setting for the film mask the software will switch from Editto New: i.e. in this case you are no longer editing the selected configuration, but youdefine a new configuration.Applies to netlab.2plusIn an existing order configuration the setting for Config. type can no longer bechanged. If you edit an order configuration the Config. type button is inactive.Applies to d-lab.2/2plusThe possible settings in the Order configuration screens depend on the selected filmmask. Below they are described for all film carriers available for the machine.4.8.1.1 Film Mask: 135, 120, 110Applies only to d-lab.2/2plus022_negsi If the Order configuration screen wascalled up with New: Press Config. type andselect Single. Press Film type and select (Color negativeor BW). Press PpF (number of prints per frame) andenter the desired value:preset value = 1 (range 0 to 999). Sub-configurations (Indexprint, Backprint,Correction, Autosave, Front print): pressthe button and select the respective subconfigurationfrom the list or set to Off. If border prints are to be printed:Press Border and enter the requiredvalue.Possible values: 4–60 mmPresetting: 0 (for borderless). Press Border color and select the desiredcolor.4-112 2005-05-01 / PN 04092_01 AgfaPhoto