RMX 2000 Administrator's Guide - Polycom Support

Polycom RMX 2000/4000 Administrator’s Guide
Table 13 Default IP Network Service – IP (Continued)
Field Description
IP Network Type Displays the network type selected during the First
Entry configuration. The Default IP Network icon
indicates the selected environment.
You can select:
• H.323: For an H.323-only Network Service.
• SIP: For a SIP-only Network Service.
• H.323 & SIP: For an integrated IP Service. Both
H.323 and SIP participants can connect to the
MCU using this service.
Note: This field is displayed in all Default IP Service
tabs.
Signaling Host IP
Address
Media Card 1
IP Address
Media Card 2
IP Address
Media Card 3
IP Address
(RMX 4000)
Media Card 4
IP Address
(RMX 4000)
Enter the address to be used by IP endpoints when
dialing in to the MCU.
Dial out calls from the RMX are initiated from this
address.
This address is used to register the RMX with a
Gatekeeper or a SIP Proxy server.
RMX 2000:
Enter the IP address(es) of the media card (s) as
provided by the network administrator:
MPM 1 and MPM 2 (if installed)
or
MPM+ 1 and MPM+ 2 (if installed) .
RMX 4000:
Enter the IP address(es) of the media card (s) as
provided by the network administrator:
MPM+ 1, and MPM+ 2, MPM+ 3, MPM+ 4 (if
installed) .
Endpoints connect to conferences and transmit call
media (video, voice and content) via these
addresses.
Subnet Mask Enter the subnet mask of the MCU.
Default value: 255.255.255.0.
12-15