RMX 2000 Administrator's Guide - Polycom Support

Polycom RMX 2000 Administrator’s Guide
Table 16-3 Manually Added System Flags – MCMS_PARAMETERS
Flag and Value Description
RMX_MANAGEMENT
_SECURITY
_PROTOCOL
SIP_ENABLE_FECC
=NO
SIP_FAST_UPDATE_
INTERVAL_ENV
SIP_FAST_UPDATE_
INTERVAL_EP
Enter the protocol to be used for secure
communications.
Default: TLSV1_SSLV3 (both).
Default for U.S. Federal licenses: TLSV1.
By default, FECC support for SIP endpoints is
enabled at the MCU level. You can disable it
by manually adding this flag and setting it to
NO.
Default setting is 0 to prevent the RMX from
automatically sending an Intra request to all
SIP endpoints.
Enter n (where n is any number of seconds
other than 0) to let the RMX automatically
send an Intra request to all SIP endpoints
every n seconds.
It is recommended to set the flag to 0 and
modify the frequency in which the request is
sent at the endpoint level (as defined in the
next flag).
Default setting is 6 to let the RMX
automatically send an Intra request to
Microsoft OC endpoints only, every 6
seconds.
Enter any other number of seconds to change
the frequency in which the RMX send the Intra
request to Microsoft OC endpoints only.
Enter 0 to disable this behavior at the endpoint
level (not recommended).
16-39