RMX 2000 Administrator's Guide - Polycom Support

Chapter 16-RMX Administration and Utilities
16-88
Table 16-18 RMX-SNMP Properties – Security Options (Continued)
Field Description
Accept Host
Community Name
(cont.)
Accept SNMP
Packets from all
Host
Accept SNMP
Packets from the
following Hosts
Note: Queries sent with different strings will be
regarded as a violation of security, and, if the Send
Authentication Trap check box is selected, an
appropriate message will be sent to the SNMP
Manager.
Select this option if a query sent from any Manager
terminal is valid. When selected, the Accept SNMP
Packets from These Hosts option is disabled.
Lists specific Manager terminals whose queries will
be considered as valid. This option is enabled when
the Accept SNMP Packets from any Host option is
cleared.
15 To specifically define one or more valid terminals, ensure that the
Accept SNMP Packets from any Host option is cleared and then click the
Add button.
The Accepted Host IP Address dialog box opens.
16 Enter the IP Address of the Manager terminal from which valid
queries may be sent to the MCU, and then click OK.
Click the Add button to define additional IP Addresses.
The IP Address or Addresses are displayed in the Accept SNMP Packets
from These Hosts box.
Queries sent from terminals not listed in the Accept SNMP Packets from These
Hosts box are regarded as a violation of the MCU security, and if the Send
Authentication Trap check box is selected, an appropriate message will be sent
to all the terminals listed in the SNMP Properties – Traps dialog box.
17 In the RMX - SNMP Properties - Security dialog box, click OK.