RMX 2000 Administrator's Guide - Polycom Support

Polycom RMX 2000/4000 Administrator’s Guide
6 Enter the IP address, Subnet mask and Default gateway for the
workstation.
The workstation’s IP address should be in the same network
neighborhood as the RMX’s Control Unit IP address.
Example: IP address – near 192.168.1.nn
None of the reserved IP addresses listed in Table G-1 should be used for
the IP Address.
The Subnet mask and Default gateway addresses should be the same as
those for the RMX’s Management Network.
The addresses needed for connection to either the RMX’s Default
Management Network or Alternate Management Network are listed in
Table G-1.
For more information about connecting to the Alternate Management
Network, see "Connecting to the Alternate Management Network” on
page G-9.
G-5