RMX 2000 Administrator's Guide - Polycom Support

Chapter 17-RMX Hardware Monitoring
17-8
To view the Card Properties:
1 In the Hardware Monitor pane, either double-click or right-click and
select properties for the desired hardware component.
The following information is displayed:
Table 17-5 Card Properties - General Info
Field Description
HW Version The hardware component’s version number.
SW Version The version number of the software installed on
card.
Serial Number The hardware component’s serial number.
Card Type Displays the type of card that occupies the slot.
Board Part
Number
Board Mac
Address 1
Board Mac
Address 2
The part number of the HW component’s board.
Specific hardware address of the component. This
address is burnt onto the component and is
automatically identified by the system.
(If applicable) second Mac address.
2 Click the Event Log tab to view a log of events that was recorded by
the system on the HW component.
For more information, see "MCU Properties - Event Log” on page 17-6.
3 Click the Active Alarms tab to view alarms related to the hardware
component, i.e. temperatures and main power sensors.
For more information, see “Active Alarms” on page 17-7.
4 Click Close to return to the HW Monitor pane.