RMX 2000 Administrator's Guide - Polycom Support

Creating/Modifying System Flags
Polycom RMX 2000/4000 Administrator’s Guide
The following System Flags in system.cfg control secure communications.
• RMX_MANAGEMENT_SECURITY_PROTOCOL
• EXTERNAL_DB_PORT
Appendix F, “System Flags” , below, lists both flags and their settings.
If the System Flag, RMX_MANAGEMENT_SECURITY_PROTOCOL does not
exist in the system, it must be created by using the RMX Setup menu.
For more information see the RMX 2000/4000 Administrator’s Guide,
"Modifying System Flags” on page 16-19.
Table F-2 System Flags
Flag Description
RMX_MANAGEMENT_
SECURITY_PROTOCOL
The RMX must be restarted for modified flag settings to take effect.
Enabling Secure Communication Mode
Enter the protocol to be used for secure
communications.
Default: TLSV1_SSLV3 (both).
Default for U.S. Federal licenses: TLSV1.
EXTERNAL_DB_PORT The external database server port used by the
RMX to send and receive XML requests/
responses.
For secure communications set the value to 443.
Default: 5005.
After the SSL/TLS Certificate is installed, secure communications are
enabled by modifying the properties of the Management Network in the
Management Network properties dialog box.
When Secure Communications Mode is enabled:
• Only https:// commands from the browser to the Control Unit IP
Address of the RMX are accepted.
• The RMX listens only on secured port 443.
• All connection attempts on port 80 are rejected.
F-5