RMX 2000 Administrator's Guide - Polycom Support

Chapter 2-Additional Conferencing Information
2-34
Move Guidelines
Encryption Flag Settings
Table 2-10 Encryption: Flag vs. Conference and Entry Queue Settings When
ISDN Participant Encryption is set to Auto (Continued)
ALLOW_NON_
ENCRYPT_PARTY_
IN_ENCRYPT_CONF
Entry Queue
Encryption
Setting
Destination
Conference
Encryption
Setting
Enable
Participant
Move from EQ
to Conference
YES No No Yes
YES No Yes Yes
• When participants are moved to another conference their encryption
settings are evaluated to determine if the move is permitted. If not,
the move fails and the participants remain in their original conference.
• When the flag is set to YES, participants can move between conferences
that have different encryption settings. For example, encrypted
participants can move to encrypted and non-encrypted conferences.
• When the flag is set to NO, the participant’s encryption setting must
match the conference encryption setting to be moved to the other
conference. For example, encrypted participants can move only from
an encrypted conference to another encrypted conference.
To modify the Encryption flag:
1 Click Setup>System Configuration.
The System Flags dialog box opens.
2 Set the ALLOW_NON_ENCRYPT_PARTY_IN_ENCRYPT_CONF
flag to YES or NO.
3 Click OK.
For more information, see "System Configuration” on page 16-19.
>> Reset the MCU for flag changes to take effect.