RMX 2000 Administrator's Guide - Polycom Support

Appendix A-Disconnection Causes
A-2
Table A-1 Call Disconnection Causes (Continued)
Disconnection Cause Description
Resources deficiency Insufficient resources available.
Call close. Call closed by
MCU
H323 call close. No port
left for audio
H323 call close. No port
left for video
H323 call close. No port
left for FECC
H323 call close. No control
port left
H323 call close. No port
left for videocont
H323 call closed. Small
bandwidth
H323 call closed. No port
left
The MCU disconnected the call.
Insufficient audio ports.
The required video ports exceed the number of
ports allocated to video in fixed ports.
The required data ports exceed the number of
ports allocated to data in fixed ports.
The required control ports exceed the number of
ports allocated to control data in fixed ports.
The required video content ports exceed the
number of ports allocated to video content in
fixed ports.
The gatekeeper allocated insufficient bandwidth
to the connection with the endpoint.
There are no free ports left in the IP card.
Caller not registered The calling endpoint is not registered in the
gatekeeper.
H323 call closed. ARQ
timeout
H323 call closed. DRQ
timeout
H323 call closed. Alt
Gatekeeper failure
H323 call closed.
Gatekeeper failure
The endpoint sent an ARQ message to the
gatekeeper, but the gatekeeper did not respond
before timeout.
The endpoint sent a DRQ message to the
gatekeeper, but the gatekeeper did not respond
before timeout.
An alternate gatekeeper failure occurred.
A gatekeeper failure occurred.