1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

FUEL SYSTEM & EXHAUST 4 - 19
6. Remove a 11 parts from the carburetor body, except
nozzles and other pressed in parts, Figure 58.
carbon from bores of flange. Replace all worn or damaged
parts and all gaskets.
After cleaning carburetor parts, group as follows:
1. Group all parts controlling gasoline level, Figure 60.
FIGURE 60
FIGURE 58
2. Group all parts controlling the idle operation, Figure 61.
7. Remove all parts from the body flange assembly, Figure
59.
FIGURE 61
3. Group all parts controlling the high speed operation,
Figure 62.
FIGURE 59
NOTE: Wash all parts in a good carburetor cleaning solution,
except the thermostatic coil and housing assembly and the
pump plunger.
CAUTION: DO NOT SOAK THE BOWL COVER
ASSEMBLY FOR MORE THAN ONE-HALF HOUR.
NOTE: Carefully note slots in choke piston cylinder.
If they are carbonized, remove the welsh plug by
piercing center with a small pointed instrument and
pry outward. Be careful not to damage the casting.
Blow out all passages with compressed air and scrape
FIGURE 62
COPYRIGHT 1950 BY CARTER CARBURETOR CORPORATION. ALL RIGHTS RESERVED.