1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

FUEL SYSTEM & EXHAUST 4 - 21
7. Install the intake ball check (G), Figure 71. Then Install
the retainer ring (H) and the strainer (I).
FIGURE 68
5. Install low speed jet assemblies, Figure 69. (No gaskets
are used.)
FIGURE 71
8. Install discharge check needle (J), Figure 72, gasket (K)
and pump jet cluster (L) and screw. (Use new gasket.)
FIGURE 69
6. Assemble body casting to flange, Figure 70. (Use new
gasket.)
FIGURE 72
9. Install lower pump spring and plunger assembly, Figure
73.
FIGURE 70
FIGURE 73
COPYRIGHT 1950 BY CARTER CARBURETOR CORPORATION. ALL RIGHTS RESERVED.