1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

4 - 8 FUEL SYSTEM & EXHAUST
4. Disconnect vacuum line from carburetor to distributor.
5. Disconnect heat riser line from exhaust manifold to
carburetor.
6. Remove nuts and lock-washers from the carburetor
mounting studs and remove carburetor assembly.
DISASSEMBLY:
1. Remove fast idle cam and pin assembly, Figure 9
FIGURE 11
4. Check throttle connector rod for wear at both ends and
at hole in pump arm. Remove bowl cover gasket and
pump spring.
FIGURE 9
2. Remove air horn and climatic control assembly, Figure
10, and lift off air horn gasket.
FIGURE 12
5. Remove the metering rod jet and gasket assembly, Figure 12.
FIGURE 10
3. Disconnect throttle connector rod; then remove bowl
cover with all parts attached. Remove throttle shaft arm
assembly.
FIGURE 13
COPYRIGHT 1950 BY CARTER CARBURETOR CORPORATION. ALL RIGHTS RESERVED.