1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

12 - 10 FRONT SUSPENSION
REMOVAL:
STEERING SPINDLE SUPPORT
adjusting plug and ball seat.
2. Remove tie rod ends (13) from steering center arm (11)
using tool J-2781.
Proceed as outlined in "Steering Spindle Removal", items
1 to 15, inclusive.
INSTALLATION:
NOTE: To install, reverse procedure of removal.
REMOVAL:
STEERING ARM
1. Remove the cotter pin; castellated nut and washer from
steering arm (14), Figure 2.
FIGURE 16
11. Center steering arm
12. Tie rod assembly
13. Tie rod ends
41. Center steering arm bolt
42. Center steering arm bracket
43. Tie rod clamp
3. Remove the 3 bolts attaching the center steering arm
bracket (42) to the No. 2 crossmember, Figure 16.
4. Remove the center pivot nut (41) and remove the steering
center arm and pivot as an assembly.
CENTER STEERING ARM
FIGURE 15
2. Remove tie rod cotter pin and castellated nut and rubber
dust cover, and remove the tie rod using tool T-2781,
Figure 15.
3. Remove steering arm using tool J-1372.
NOTE: To install, reverse procedure of removal.
Tighten the steering arm nut with a torsion wrench to 110
to 120 foot pounds.
REMOVAL:
CENTER STEERING ARM
1. Remove draglink (15), Figure 2 at front by backing off
INSTALLATION:
FIGURE 17
1. When installing new bearings in steering center arm
bracket (E) space as shown in