1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

4 - 24 FUEL SYSTEM & EXHAUST
20. Install metering rods. Catch the metering rod spring
loop with lower end of the, metering rod as rods are
inserted (W), Figure 84. Adjust metering rods in the
following manner:
a. Back out the throttle lever adjusting screw so
throttle valves seat.
b. Loosen metering rod arm set screw.
c. Press down on the vacumeter link until metering
rods bottom in body casting.
d. With torque on arm touching lip (top of slot) of
link, tighten metering rod arm set screw.
e. Install dust cover gasket, dust cover and screws.
FIGURE 86
23. Connect the fast idle cam spring to the choke piston
lever at (X), Figure 87.
FIGURE 84
21. Install fast idle cam and spring as indicated by arrow,
Figure 85.
FIGURE 87
24. Install choke valve using new screws.
FIGURE 85
22. Install choke piston, lever, link and shaft, Figure 86.
FIGURE 88
COPYRIGHT 1950 BY CARTER CARBURETOR CORPORATION. ALL RIGHTS RESERVED.