1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

4 - 12 FUEL SYSTEM & EXHAUST
FIGURE 31
FIGURE 34
12. Install pump check ball and pump discharge ball
retainer and gasket, Figure 31.
If jet is worn, replace both metering rod and jet.
FIGURE 32
13. Install pump intake check ball and pump strainer,
Figure 32.
FIGURE 35
16. Install the bowl cover assembly, Figure 35. Pull the
screws down evenly. Install idle passage plug and
gasket assembly (center of bowl cover).
FIGURE 33
14. Install pump spring and pump plunger and rod
assembly, Figure 33. Examine leather of
plunger for damage. If leather is not in good
condition, replace entire plunger assembly.
15. Install metering rod jet and gasket assembly, Figure 34.
Examine for wear.
FIGURE 36
17. Install the anti-percolator cap and rocker arm assembly
and spring, Figure 36. (Make certain that leather
is in good condition and that pin is not worn.)
COPYRIGHT 1950 BY CARTER CARBURETOR CORPORATION. ALL RIGHTS RESERVED.