1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

FUEL SYSTEM & EXHAUST 4 - 23
FIGURE 79
FIGURE 81
16. Install vacumeter spring (R), Figure 80, in cylinder and
assemble bowl cover on body. (Install bowl cover
screws, tightening center screws first.)
FIGURE 82
19. Set pump stroke, Figure 83, (see Page 16, for pump
stroke setting).
FIGURE 80
17. Install pump connector link (S), Figure 81 in outer hole
of pump arm and Install hair pin clip. Insert the lower
end of pump connector link in hole in plunger shaft.
Hold arm (R) in place and press shaft through arm.
Hold metering rod arm (U) with lip extending through
slot in vacumeter piston link and press shaft in place.
Tighten pump arm (T) screw and metering rod arm (U)
screws.
18. Install the throttle shaft lever, washer and screw at (V),
Figure 82. Install throttle connector rod and retainer
clips.
FIGURE 83
COPYRIGHT 1950 BY CARTER CARBURETOR CORPORATION. ALL RIGHTS RESERVED.