1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

FUEL SYSTEM & EXHAUST 4 - 25
NOTE: Choke valve to be Installed with the circled
"C" visible from the top of the carburetor with valve
in closed position as indicated by an arrow, Figure
88. Seat choke valve by tapping lightly; hold in place
with fingers before tightening screws. Valve or shaft
must not bind in any position. Peen threaded end of
screws to prevent screws from loosening.
25. Install the fast idle link, choke connector
rod and retainer clip, Figure 89.
FIGURE 91
28. Check the unloader adjustment as follows: With the
throttle valves wide open, bend lip (Z), Figure 92, on
choke trip lever to get clearance between top edge of
choke valve and inner wall of air horn. See Page 4-17,
"Covering Unloader Adjustment."
FIGURE 89
26. Install choke trip lever assembly, Figure 90
.
FIGURE 92
29. Install choke baffle plate and gasket, Figure 93.
FIGURE 90
27. With the choke valve tightly closed, adjust the fast idle
by bending choke connector rod at the lower angle (Y),
Figure 91; to give proper clearance between the throttle
valve and base of carburetor. See "Fast Idle Adjustment",
Page 4-17.
FIGURE 93
COPYRIGHT 1950 BY CARTER CARBURETOR CORPORATION. ALL RIGHTS RESERVED.