1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

4 - 14 FUEL SYSTEM & EXHAUST
with indicator marks at bottom and rotate counter
clockwise to center graduation.
FIGURE 42
24. Install air horn and piston housing assembly, Figure
42. Install screws and lock-washers. Tighten
screws evenly.
FIGURE 45
FIGURE 43
FIGURE 46
25. With choke lever, screw and link assembly in place,
Install choke shaft and piston assembly, Figure 43.
Check for loose lever on shaft.
28. Hold choke valve wide open, then tighten the
choke lever screw as shown in Figure 46. Be sure
that linkage does not bind in any position. Fast
idle, unloader and lock out adjustments should be
made as specified under "Carburetor Adjustments.
FIGURE 44
26. Install choke valve, Figure 44. Center choke valve
on shaft and in bore by tapping lightly. Hold in
place with finger while tightening screws. Peen
ends of screw threads to keep screws from loosening.
27. Install the piston housing and thermostatic coil
assembly, Figure 45. Install coil housing assembly
FIGURE 47
29. Install fast idle cam and pin assembly, Figure 47.
COPYRIGHT 1950 BY CARTER CARBURETOR CORPORATION. ALL RIGHTS RESERVED.