07.07.2014 Views

1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

1948-1952 Shop Service Manual - - Hudson-Essex-Terraplane Club

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

LUBRICATION 1 - 5<br />

WATER RESISTANT LUBRICANT<br />

Windshield Cables at Pulleys<br />

Door Check Arms<br />

Courtesy Light Switch<br />

Door Lock Bolt and Slide<br />

Door Striker<br />

Rear Compartment Door Hinge<br />

Points<br />

4<br />

2 or 4<br />

2 or 4<br />

2 or 4<br />

2 or 4<br />

2<br />

Rear Compartment Door Latch and<br />

Striker<br />

Hood Prop<br />

Hood Upper Lock<br />

Hood Lower Lock<br />

Hood Lower Lock and Control Wire<br />

Points<br />

2<br />

2<br />

1<br />

1<br />

2<br />

GEAR LUBRICANT<br />

Transmission<br />

Overdrive Check Level<br />

Steering Gear Check Level<br />

S.A.E. 80 Winter<br />

S.A.E. 90 Summer<br />

Check Level<br />

Check Level<br />

Check Level<br />

Rear Axle Check Level<br />

Multi -Purpose Gear Lubricant-S.A.E. 90<br />

Check Level<br />

Universal Joint Needle Rollers - 3 Points<br />

Gear Oil - S.A.E. 140<br />

Check Battery Electrolyte level and gravity.<br />

Water or Anti-Freeze<br />

Check Coolant Level and Anti-Freeze strength.<br />

<strong>Hudson</strong> Hydraulic Brake Fluid<br />

Check Brake Master Cylinder fluid level.<br />

Hydra-Matic Transmission - Check Level<br />

2,000 Miles<br />

Perform operations included in 1,000 mile lubrication, in<br />

addition to the following: FIGURE 3<br />

Hydra-Matic transmission fluid level should be checked when a chassis lubrication is being performed.<br />

The procedure for checking fluid level is included on pages 41 and 42 in Hydra-Matic Section No. 11.<br />

Engine Oil<br />

Engine<br />

Generator<br />

Distributor<br />

Air Cleaner - Standard<br />

Air Cleaner - Oil Bath<br />

Throttle Operating Linkage<br />

Oil Filler Pipe Cap<br />

Brake Operating Linkage<br />

Hydra-Matic Linkage<br />

Drain Oil and Refill<br />

2 Points<br />

4 Points<br />

Wash and re-oil<br />

Clean and add new oil<br />

All Joints<br />

Wash and re-oil<br />

All Joints<br />

Lubricate using light engine oil

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!