Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 3: R8si R8r Gateway
R8si
3 C-LAN Administration
Switch 1 Task — Assign Node Names
This task assigns node names and IP addresses to each node in the network. This
screen is administered on Switch 1. A Node Names screen must be administered on
each switch in the network.
A node is defined as any of the following — a C-LAN port, a bridge or router, a CMS
ethernet port, or an Intuity AUDIX or other MSA network interface card. The Audix
and MSA node name and IP address must be entered on page 1 of the screen. The data
for all other node types must be entered on pages 2–6.
The node names and IP addresses in any network should be assigned in a logical and
consistent manner from the point of view of the whole network. These names and
addresses should be assigned in the planning stages of the network and should be
available from the customer system administrator or from a Lucent representative.
Note:
Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter
node names for switches, routers, and CMS starting on page 2.
Steps
Begin
> Open Node Names form — enter ch node-n
> Go to page 2.
change node-names
NODE NAMES
Page 2 of 6
Name IP Address Name IP Address
default________ 0__.0__.0__.0__ _______________ ___.___.___.___
node-1 __ 192.168.10_.1__ _______________ ___.___.___.___
node-3___ 192.168.10_.3__ _______________ ___.___.___.___
_____________ _ ___.___.___.___ _______________ ___.___.___.___
> Enter values.
Field
Name
IP Address
Conditions/Comments
Enter unique node names for the following 2 nodes:
• C-LAN Ethernet port on Switch 1
• C-LAN Ethernet port on Switch 3.
The unique IP addresses of the nodes named in the previous
field.
> Submit the screen
End
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
101