Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 1: R8r R8si
3 C-LAN Administration
Switch 1 Task — Assign Processor Channels
This task associates data links (hardware) with processor channels (software) on
Switch 1 and specifies the destination node and machine ID.
Steps
Begin
> Open the Processor Channel Assignment form — enter ch com p
change communications-interface processor-channels
PROCESSOR CHANNEL ASSIGNMENT
Page 1 of X
Proc Gtwy Interface Destination Session Mach
Chan Enable Appl. To Mode Link/Chan Node Port Local/Remote ID
1: n _______ _ __ _____ __________ 0____ ___ ___ __
2: n _______ _ __ _____ __________ 0____ ___ ___ __
:
12: y dcs ___ s 1_ 5003 node-2____ 0____ 12_ 21_ 2_
:
64: n _______ _ __ _____ __________ 0____ ___ ___ __
> Enter values for processor channel 12
Field
Conditions/Comments
Enable Set to y.
Appl.
Set to dcs for DCS signaling.
Mode
node-1 is the "server" for this session. Set node-2 to "client"
(c).
Interface Link This must match the link number assigned on the node-1
data module screen in the previous task.
Interface Chan For TCP/IP, interface channel numbers are in the range 5000
– 64500.
The recommended values are: 5001 for CMS, 5002 for
Intuity AUDIX, and 5003 for DCS connections that are not
gateways. These three values should be reused for multiple
instances of these applications; for example, if there are two
Intuity AUDIX’s, use 5002 for both; or if there are four
DEFINITY ECS’s, use 5003 for all four. The combination
of Link, Interface Channel, and Mach ID must be unique.
The recommended values for gateway switches is
6001–6099. The interface channel number must be unique
for each gateway.
This number must match the Destination Port number on the
node-2 Processor Channel screen.
1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
65